Аутори:
1. Miloš Madić, Serbia
2. Miroslav Radovanović, Универзитет у Нишу, Машински факултет, Serbia
3. Srđan Mladenović, Универзитет у Нишу, Машински факултет, Serbia
4. Dušan Petković, Универзитет у Нишу, Машински факултет, Serbia
5. Predrag Janković, Универзитет у Нишу, Машински факултет, Serbia

Апстракт:
This study presents experimental results regarding kerf width obtained in CO2 laser cutting of aluminum alloy AlMg3. Laser cutting experiment, conducted according to the full factorial design, where three laser cutting parameters (laser power, assist gas pressure and cutting speed) were varied at three levels, provided a set of experimental data for the development of mathematical model for the prediction of the kerf width. Statistically assessed as adequate, the developed mathematical model was used for the analysis of interaction effects of selected laser cutting parameters on the kerf width. It was observed that assist gas pressure predominantly affects the laser cutting process of aluminum-magnesium alloy considering kerf width.

Кључне речи:
CO2 laser cutting,aluminum-magnesium alloy,kerf width

Тематска област:
Производне и рачунаром подржане технологије

Датум пријаве сажетка:
04.05.2015.

Конференцијa:
12th International conference on accomplishments in Electrical and Mechanical Engineering and Information Technology (DEMI 2015)

Финални рад